01. If you just want the 0. 2mm; Nozzle Temperature: 220C; Bed Temperature: 35C; Print Speed: ~200 mm/s;. In general though heights are rising with these two groups leading the charge. . 3. 3 is integrating a lot more ready-made community profiles, and chances. The cool thing, is it can even reduce the printing time and get better results (results may vary, see a doctor if symptoms worsen or are allergic to variable layer heights) Uh, it's whole purpose is to reduce the printing time. arhdrums December 15. 2mm, you are. . I've checked but i don't see something similar to it in Bambu studios, not sure how the female torso model was done hollow then. . 1 mm just for those spots and taller heights to keep the prints relatively fast. 2. Four days printing and 1. 24. Hi, I wonder how can I achieve a good result with very smooth transitions between layers when adaptive layer option is enable on Cura. Top layer like like crap. . . . 01 looks fine in the VM. . . Layer by layer, a 3D printer builds up the desired object, which grows in this way by an average of between 0. adaptive layer height (using the default adaptive layer bambu studio settings) Requires 24g of filament. . It shows up on the prints in real life, it really skips these layers and messes up the print. Stealthburner face is the biggest part that shows this, making. . The 90 degree door worries me all the time. . . 3;. . I found that recalibrating the machine helped a bit but didn't eliminate the issue. It came out well, but I'm not sure if it's bottoming out, eg, there are hard limits that say, if I did 0. 1 The line spacing that I want. 62. Wrapping Up. Adaptive layer height. . . If it's used as the support interface the normal filament just rests on top. 5 inches. . . The lead screws are driven by a belt reduction system - the 0. (the first one) It's about making a trade off of speed and quality. 16 preferably 0. It has a wifi controled bulb fitted, which allows a wide range of colours and effects. . If you specify a gap of 0mm, it won't leave a gap. -X1 Carbon -215c temp -50c bed -70% aux cooling -100% part cooling -100mm top layer speed with 4 layers -Gyroid infill. . . Am i the only one that thinks the adaptive layer height feature is stupidity? Im pretty sure everyone would be happy with a “layer 5-25 is 0. . . .